Q1. What is an eccentric half ball valve used for, and where is it used?
A1. A ball valve isolates or switches flow with a quarter turn of a bored ball. It is used wherever the valve is operated often or has to be operated quickly and visibly: on-off duty on water, oil, gas and chemicals, at the inlet and outlet of instruments and small pumps, on manifold and sampling points, on filling and emptying connections, and on gas lines where a tight seal matters. Compared with a gate valve the advantages are speed, a seal made by a seat that wipes itself as the ball turns, and no cavity in line with the flow. The limits come from the seat material: the polymer seats that give bubble-tight shut-off set a temperature ceiling, and the bore through the ball adds a small pressure loss that a full-bore design is used to avoid.
Q2. What design variants are available, and how do I tell them apart?
A2. Two design families matter. A floating ball is pressed against the downstream seat by the line pressure itself; it is simple, seals well in the smaller sizes and is the usual choice up to about DN200. A trunnion-mounted ball is supported top and bottom in bearings so the seats are loaded by a spring rather than by the line, which is what allows large sizes and high pressure to be handled with a low operating torque. Body construction is one-piece, two-piece or three-piece, the choice being driven by whether the valve must be serviced in line. Port can be full bore or reduced, and the seat is either soft or metal.
Q3. Which standards is this valve designed and tested to?
A3. Where a customer specifies a different standard — DIN, EN, GB or a client specification — it can be worked to, but it should be named at enquiry stage, because it changes dimensions, the material list and the test acceptance at the same time. Two details are worth settling early because they are easy to leave to assumption: the revision of the standard that applies, and which edition of the pressure–temperature tables is being used for the rating.
Q4. How is the valve pressure tested before delivery?
A4. Every valve is shell-tested and seat-tested before dispatch. The shell test is at 1.5 times the rated pressure at 38 °C with the valve partly open, proving the pressure boundary; the seat test is at 1.1 times with the valve closed, proving the closure. Holding time follows the standard and the size. Acceptance is normally quoted against ISO 5208: Rate A means no visible leakage, while lower rates permit a defined leakage over the test period. The rate that applies should be written into the specification — on gas, toxic or metered service Rate A is the usual requirement.
Q5. How does it compare with the alternative valve types on the same line?
A5. The alternatives worth comparing are the ones that could do the same job at a different cost. A butterfly valve is lighter and cheaper as size grows and needs little space, but its disc sits in the flow and its seat is more easily damaged. A gate valve costs more at small sizes but holds tight more easily and gives an unobstructed bore when open. A ball valve gives quarter-turn operation and is better where the valve is cycled often. A globe valve is chosen only when some regulation is wanted, because it costs permanent pressure drop. A check valve is not an alternative to any of them — it prevents reverse flow and cannot isolate.
Q6. How do I select the right one for my line?
A6. State the standard you want the valve built to, and the revision, rather than assuming one. A valve can be built to ASME, DIN, EN, GB or a client specification, and the choice changes face-to-face dimensions, flange drilling, the material list and the test acceptance at the same time — so it cannot be settled after the order. Where no standard is named, say which dimension is critical on your line: the face-to-face length where space is tight, or the flange drilling where the valve must bolt up to an existing flange.
Q7. How do I order, and what information is needed for a quotation?
A7. Give us the service conditions rather than only a model number: size, pressure rating, medium, temperature and connection. Where a standard applies, name it and the revision. Custom work is normal in this range — end connections, operator type, trim material and surface treatment are all specified per order.
